-
Ay up lads, back after a dig in the ribs by Neil 😉
Broke my M3K +10 magtube when it got dented and won’t reshape easily. The follower sticks and the tubes basically nadgered. Magload helped out with a carbon extension so I just need to cut the tube in front of the threaded section and a bit of tidying, hey presto.
At the time of writing the carbon tube is curing but when it’s here I’ll take a few pics and describe the upgrade.
What could possibly go wrong?
Neil Wragg-
Sounds interesting buddy, not had any issues with mine as of yet…
-
Couldn’t believe it when I tried to load four it went fine, next pair wouldn’t go in. Interesting for the RO as I had to strip the gun on the start position to make safe. Looking at the follower in the tube you can see the deformed bit snagging the edge. I’ll try to get a decent pic for a follow up.
-
Here’s a few snaps before during and after, not a difficult job and the gun is now upgraded from the factory tube.
-
Im thinking of doing the same to mine
what Size tube did you buy ?-
Hey Angelo hope you’re doing good. I went for the +6 for that bit extra capacity. Same price.
-
thanks 🙂 have you measured the overall length of the gun since adding this tube ?
-
127.5cm
-
-
-
-
-
-
-